Acid-base properties of xanthosine 5'-monophosphate (XMP) and of some related nucleobase derivatives in aqueous solution: micro acidity constant evaluations of the (N1)H versus the (N3)H deprotonation ambiguity

The first acidity constant of fully protonated xanthosine 5'-monophosphate, that is, of H3(XMP)+, was estimated by means of a micro acidity constant scheme and the following three deprotonations of the H2(XMP)+/- (pKa=0.97), H(XMP)- (5.30), and XMP2- (6.45) species were determined by potentiometric pH titrations; further deprotonation of (XMP-H)3- is possible only with pKa>12. The most important results are that the xanthine residue is deprotonated before the P(O)2(OH)- group loses its final proton; that is, twofold negatively charged XMP carries one negative charge in the pyrimidine ring and one at the phosphate group. Micro acidity constant evaluations reveal that this latter mentioned species occurs with a formation degree of 88 %, whereas its tautomer with a neutral xanthine moiety and a PO3(2-) group is formed only to 12 %; this distinguishes XMP from its related nucleoside 5'-monophosphates, like guanosine 5'-monophosphate. At the physiological pH of about 7.5 mainly (XMP-H)3- exists. The question, which of the purine sites, (N1)H or (N3)H, is deprotonated in this species cannot be answered unequivocally, though it appears that the (N3)H site is more acidic. By application of several methylated xanthine species intrinsic micro acidity constants are calculated and it is shown that, for example, for 7-methylxanthine the N1-deprotonated tautomer occurs with a formation degree of about 5 %; a small but significant amount that, as is discussed, may possibly be enhanced by metal ion coordination to N7, which is known to occur preferably to this site.     

Aging effect on the mechanical properties of hybrid gels

Sol-gel derived unsupported films and thin rods have been obtained from co-hydrolysis of triethoxysilane and methyldiethoxysilane. The materials are flexible, dense and transparent. Films and rods have been aged for different periods of time in air at room temperature. The elastic modulus has been measured by means of tensile or flexural tests. Measurements showed an increase of elastic modulus with aging time and showed different values for films and rods. The observed evolution of mechanical properties has been related to a corresponding structural modification as highlighted mainly by MAS-NMR studies. Analyses pointed out the crucial role of condensation processes and showed that the stiffness increase arises from the formation of relatively few bonds which link and constrain pre-existing mobile network regions.     

Modeling research in low-medium temperature geothermal field, Tianjin

The geothermal reservoir in Tianjin can be divided into two parts: the upper one is theporous medium reservoir in the Tertiary system; the lower one includes the basement reservoir inLower Paleozoic and Middle-Upper Proterozoic. Hot springs are exposed in the northern mountainand confined geothermal water is imbedded in the southern plain. The geothermal reservoir is in-cised by several fractures. In recent years, TDS of the geothermal water have gone up along withthe production rate increasing, along the eastern fracture zone (Cangdong Fracture and West Bai-tangkou Fracture). This means that the northern fracture system is the main seepage channel ofthe deep circulation geothermal water, and the reservoir has good connection in a certain area anddefinite direction. The isotopic research about hydrogen and carbon chronology indicates that themain recharge period of geothermal water is the Holocene Epoch, the pluvial and chilly period of20 kaBP. The karst conduits in weathered carbonate rocks of the Proterozoic and Lower Paleozoicand the northeast regional fracture system are the main feeding channels of Tianjin geothermalwater. Since the Holocene epoch, the geothermal water stayed at a sealed warm period. Thetracer test in WR45 doublet system shows that the tracer test is a very effective measure forunderstanding the reservoir's transport nature and predicting the cooling time and transportvelocity during the reinjection. 3-D numerical simulation shows that if the reinjection well keeps asuitable distance from the production well, reinjection will be a highly effective measure to extractmore thermal energy from the rock matrix. The cooling of the production well will not be a problem.     

茉莉醛相转移催化合成法的改良

茉莉醛又称2-戊基肉桂醛,具有优雅的茉莉花香,是一种深受调香师喜爱的合成香料。目前已广泛应用于各种日用化学品中。     

Determination of various deformation processes in impact-modified PMMA at strain rates up to 105%/min

The deformation processes in impact-modified PMMA, which deforms homogeneously, were determined by means of the stress/strain experiment (, ) with simultaneous lateral strain measurement (_lat) in a wide range of strain rates () up to 10⁵%/min (impact stress). The elastic, plastic cavitation and plastic shear processes were determined as a function of strain. Therefore we calculated the elastic strain ( _el), the elastic volume expansion ( _{vol el}), the cavitation strain ( _cav), which is identical with the plastic volume expansion ( _{vol pl}), the shear strain ( _sh) and the energy densities (W_el, W_cav, W_sh) related to these three processes.For strains of 3 % onward it was found that plastic shear processes and plastic cavitation processes are responsible for a partial loss of elastically stored energy. Both plastic processes turn out to be mostly anelastic deformations, their amount depending strongly on the strain rate. The contributions of the processes to the total deformation of the unmodified PMMA in its strain range are similar to those of the impact-modified PMMA, and the high impact strength is caused by a shift of the catastrophic rupture to very high strains.     

STUDY ON THE PROPERTIES OF BLEND OF NATURAL RUBBER LATEX/METHYL METHACRYLATE GRAFTED RUBBER LATEX BY GAMMA RADIATION

Natural rubber latex(NRL)and methyl methacrylate(MMA)grafted rubber latex were blended in different ratios and irradiated at various absorbed doses by gamma rays from Co-60 source at room temperature.The tensile properties, swelling ratio and permanent set were measured.The maximum tensile strength and modulus at 500% elongation were obtained at an absorbed dose of 8 kGy.Modulus increases from 6.99 MPa to 9.87 MPa for an increase in proportion of MMA grafted rubber from 40% to 60% in the blend at similar absorbed dose.Elongation at break and swelling ratio decrease with increasing absorbed dose as well as the MMA grafted rubber content in the blends.The decreasing trend of permanent set is high up to 5 kGy absorbed dose,and beyond that dose,it becomes almost flat.     

Characterisation of inhibitors of acetylcholinesterase by an automated amperometric flow-injection system

Acetylcholinesterase was immobilised on magnetic particles and integrated in a flow-injection system via a magnetic reactor. Enzyme activity was determined amperometrically using acetylthiocholine chloride as enzyme substrate. This system was applied to enzyme inhibition tests. Inhibition constants and lower detection limits were determined for carbofuran, paraoxon, malaoxon and paraoxon-methyl. The resulting data were compared to those obtained with a photometric test, i.e. the determination of thiocholine via its reaction with the Ellman's reagent 5,5'-dithio-bis-2-nitrobenzoic acid using the same flow system. As they correlated well to those reported for the native enzyme the flow-injection analysis device can be applied to automated determination and characterisation of enzyme inhibitors.     

Development of a one-step immunochromatographic strip test for the rapid detection of nevirapine (NVP), a commonly used antiretroviral drug for the treatment of HIV/AIDS

Currently, high-performance liquid chromatographic (HPLC) methods are mainly used to measure antiretroviral plasma concentrations in HIV-infected patients. Although the utility of routine therapeutic drug monitoring (TDM) as an additional tool to optimize long-term antiretroviral therapy is unclear, if TDM is to be widely used, the availability of simple, cheap and reliable methods for the measurement of antiretroviral drug levels are needed, particularly in resource-limited settings. In this study, an immunochromatograhic (IC) strip test to detect the presence of nevirapine (NVP) in body fluids has been developed. Antiserum to NVP was first raised in rabbits by immunization against NVP chemically conjugated with bovine serum albumin, and subsequently validated by Western immunoblotting and competitive indirect ELISA. The partially purified anti-NVP antibodies were conjugated with colloidal gold particles. The conjugation of the colloidal gold and polyclonal antibodies was monitored by UV-vis spectroscopy, while transmission electron microscopy images were used to characterize the particle size and shape of the conjugates. The resulting colloidal gold conjugates were used for the production of an IC strip test to detect nevirapine in human plasma. Preliminary assessment suggests no-cross reactivity of the NVP polyclonal antibodies but assessment of plasma samples from HIV-infected patients receiving HAART needs to be conducted. This assay could potentially be used for drug monitoring as part of the clinical care of HIV infected patients.     

Synthesis of spherical microcapsules by photopolymerization in aerosols

 The preparation of polymer microcapsules of well defined size in the range of 10–50 μm with different shell thickness to core diameter ratios is described. An aerosol of monodisperse droplets of a homogeneous ternary liquid system which contained a hydrophobic component and a hydrophilic component dissolved in a high-volatile mutual solvent, was produced by dispersing with a vibrating-orifice aerosol generator. After the evaporation of the solvent in a nitrogen atmosphere the particles demix and form a two-phase droplet of core-shell type. These droplets were illuminated with UV light and polymerized to highly monodisperse microcapsules with a solid polymer shell and a liquid core. The properties of the resulting particles (size, size distribution, shell thickness, shape and surface characteristics) were investigated by scanning electron microscopy, Raman spectroscopy on single optically levitated particles, and confocal Raman micro spectroscopy. The microcapsules were highly monodisperse and have spherical shape. Received: 24 July 1996 Accepted: 29 August 1996